102mm > 76mm Silicone Hose 45 Degree Elbow Reducer Blue

📏 102mm TO 76mm INTERNAL DIAMETER (ID) - Large end 102mm (4"), small end 76mm (3"). 5.5mm wall, giving an Outside Diameter (OD) of 113mm and 87mm. 150mm legs. Measure the outside of both pipes you are joining and match them to the two ID sizes. 🔧 OFFSET AND REDUCER IN ONE - Turns 45 degrees and steps down in size in one moulded part, saving an elbow, a reducer and a joint. Typical uses at this size: air intake and induction pipework, airbox connections, and large bore marine and industrial ducting. For air, water and coolant; not suitable for fuel or oil (choose our Fluoro Lined fuel and oil hose for those). 🌡️ -50°C TO +250°C OPERATING RANGE - Rated -50°C to +250°C, so it copes on intake and induction pipework next to hot engine parts. Working pressure 2.8 bar, burst pressure 8.5 bar (3:1 safety factor). Bend radius 70mm. 🛡️ SAE J20 R3, 4 PLY POLYESTER REINFORCED - Smooth extruded silicone inner with 4 layers of polyester fabric in the 5.5mm wall, so it holds its shape under pressure and resists swelling. The silicone resists ozone, UV light, weathering and ageing, so it lasts outdoors and in the engine bay without perishing. 🔵 BLUE - FITTING TIP - Push the hose fully onto the pipe, then use hose clips that cover about 87mm on the small end and 113mm on the large end. Blue silicone gives a bright show-car look that stands out under the bonnet and is easy to trace. Also available in other colours and sizes.