15mm x 1/2 Inch Solder Ring Bent Tap Connector Bag of 10

IMPORTANT SIZING NOTE - Most plumbing products are measured using BSP thread dimensions which measure 1/4 inch larger than that stated, therefore this 1/2 Inch BSP thread actually measures 3/4 Inch in diameter. If your thread measures 1/2 Inch in diameter then you require the 1/4 Inch version of this product This listing is for a Pack of 10 To solder an end feed fitting, clean and flux the joint, assemble it, heat the copper evenly with a blowtorch until it reaches melting temperature, and apply solder wire to the socket edge so capillary action draws the molten metal into the gap around the entire pipe. The solder joints in solder ring fittings are factory-applied, ensuring consistent quality and reliability across all fittings, reducing the risk of installation errors or leaks. Solder ring fittings provide a tight and durable seal between pipes, minimizing the risk of leaks and water damage in plumbing systems.