15mm x 1/2 Inch Solder Ring Straight Tap Connector Bag of 10

IMPORTANT SIZING NOTE - Most plumbing products are measured using BSP thread dimensions which measure 1/4 inch larger than that stated, therefore this 1/2 Inch BSP thread actually measures 3/4 Inch in diameter. If your thread measures 1/2 Inch in diameter then you require the 1/4 Inch version of this product This listing is for a Pack of 10 To solder an end feed fitting, clean and flux the joint, assemble it, heat the copper evenly with a blowtorch until it reaches melting temperature, and apply solder wire to the socket edge so capillary action draws the molten metal into the gap around the entire pipe. To prepare copper pipe for solder ring fittings, cut it square, deburr the edges, clean the pipe end and fitting socket to bright metal with an abrasive pad, and apply a thin layer of flux before assembly. WRAS Approved, Weight: 0.661386786 pounds, Manufacturer: Cubralco