24 Pin ATX Red LED Power On/Off Switch Jumper Bridge Adapter Braided Cable 21.5 inch(55cm)

🔹 55CM EXTENDED LENGTH FOR TEST BENCHES & PC REPAIR ⚠️ Unlike short 20cm jumpers, this 55cm (21.6in) cable allows you to route the switch outside the case or across a test bench. Ideal for PC technicians, miners, and bare-case builds. Easily power on your motherboard without shorting pins with a screwdriver. 🔹 RED LED INDICATOR — CONNECTS TO POWER LED (PLED) ⚠️ Equipped with a Red LED to indicate power status. ⚠️ Polarity matters for the LED. If the LED does not light up after turning on the PC, simply unplug and flip the 2-pin LED connector (LED+ and LED-) . The Power Switch (PW) pins are non-polarized and will work either way. Please check your motherboard manual for the F_PANEL/JFP1 layout. 🔹 BRAIDED SLEEVE FOR DURABILITY & AESTHETICS Premium braided sleeving protects the internal wires from friction, nicks, and accidental pulls. Looks much cleaner than standard bare red/black wires. The premium Dupont 2.54mm connectors ensure a snug fit into the motherboard header without bending pins. 🔹 PREMIUM DUPONT CONNECTORS — SNUG FIT WITHOUT BENDING PINS The motherboard header pins (JFP1/F_PANEL) are small and delicate. Our connectors are precisely molded for a snug fit. ⚠️ Do not force the connectors. If it does not slide in easily, check your orientation. Suitable for all standard ATX, Micro-ATX, and Mini-ITX motherboards (ASUS, MSI, Gigabyte, ASRock). 🔹 3-PIN/2-PIN SPLIT DESIGN — WIDE COMPATIBILITY The split 2-pin female headers (one for Power SW, one for Power LED) allow flexible connection to standard motherboard front panel headers. If your motherboard has a solid 3-pin block for the LED, you can connect the 2-pin into the first two pins. (Please refer to your motherboard manual for exact pinout). ⚠️ IMPORTANT NOTES: LED polarity: If the red light does not turn on, flip the LED connector 180°. Switch polarity: The Power SW connector is non-polarized. Do not force connectors: Check the pin alignment before pushing. For standard motherboards only: Not compatible with proprietary Dell/HP motherboards (they use different front panel designs). Insulation: Do not cut or strip the braided cable.