3528 2835 2 Pin 8mm Led Strip Connector DIY to Wire Quick Solderless Connection for 12v 24v Single Color Lights (Pack of 10)

Clip On, Adjust, and Reuse Without Damaging Your Strip: The flip-latch design applies even pressure across the copper pads instead of piercing them. If polarity is reversed, simply open, flip, and reconnect — no need to cut or replace your strip Handles Typical LED Loads Without Overheating at the Joint: Rated up to 6A for 5V–24V systems, suitable for SMD single colour LED strip runs. Supports 20–22 AWG two-core cable, both solid and stranded. Made from flame-retardant polycarbonate. Indoor use only IP20 Suitable for Kitchen Cabinets, Shelves and Tight Spaces: Connect LED tape under cupboards, along shelving, inside wardrobes, or behind TVs where soldering tools are impractical for quick home upgrades without specialist tools Works with Standard and IP65 Strips with Simple Prep: For coated strips, peel back the silicone over the copper pads before inserting. Not compatible with 10mm strips, RGB multi-colour strips, or COB strips wider than 8mm Flexible Setups and Future Adjustments: Use these connectors between your LED strip and power supply or dimmer. Suitable for projects where layouts may change, such as rented homes, display setups, or seasonal lighting Quick Installation Process: Open the latch, insert the strip fully, close it, then connect your wire with matching polarity. The process takes only a few seconds per connection and requires no additional tools Value Pack of 10 Connectors: Includes 10 white 8mm 2 pin LED strip connectors, providing enough quantity for multiple connection points throughout your lighting project