3mm x 7mm Red Silicone Vacuum Tubing Rubber Hose Air Water 1/2 Metre

📏 3MM ID x 7MM OD, 0.5M LENGTH – 3mm (1/8") internal diameter, 7mm (9/32") outside diameter and 2mm wall, supplied as one continuous 0.5 metre length (1.6ft, approx. 14g). Choose the ID that matches the spigot you are fitting to. 🔧 MULTI-PURPOSE SILICONE TUBING – for cars, vans, motorbikes, boats and machinery. The 3mm bore suits MAP sensor and boost-control signal lines, wastegate actuator, dump valve and fuel-pressure-regulator vacuum references; also ideal for workshop air lines and low-pressure water transfer. 🌡️ -60°C TO +180°C RATED – continuous operating range -60°C to +180°C with peaks to +200°C. Extruded VMQ silicone to SAE J20 R3 grade stays flexible from cold starts to full engine-bay heat and will not harden, crack or perish like rubber. 🛠️ UNREINFORCED, EASY TO ROUTE – a single wall of silicone with no fabric ply, so it bends round tight routes and seals well on push-on spigots. Made for vacuum, signal, air and low-pressure water lines – not for pressurised coolant, fuel or oil; very tight bends can kink. 🔴 RED SILICONE – bright red finish for race bays and easy line tracing. Trim square with a sharp blade and secure with mini hose clips sized for the 7mm outside diameter.