60mm ID Blue 45 Degree Flouro Lined Silicone Elbow Fuel and Oil Hose AutoSi...

📏 60mm (2 3/8") INTERNAL DIAMETER (ID) FLUORO LINED 45 DEGREE FUEL & OIL ELBOW - 5.5mm wall and an Outside Diameter (OD) of 71mm. 300mm long on each leg, so there is room to trim either end to fit. Match the ID to the outside of the pipe or outlet it pushes onto. 🔧 MADE FOR FUEL AND OIL - The fluorosilicone inner liner is made for fuel and oil, so this 45 degree elbow can go where a standard silicone hose cannot. Typical uses at this size: fuel feed and return lines, oil breather and catch can hoses, and turbo oil feed and drain pipework. 🌡️ -50°C TO +250°C OPERATING RANGE - Rated -50°C to +250°C, so it copes around hot fuel rails, sumps, oil coolers and turbo oil lines. Working pressure 4.2 bar, burst pressure 12.5 bar (3:1 safety factor). Bend radius 60mm. 🛡️ SAE J30 R6, FLUOROSILICONE LINED - A fluorosilicone inner liner carries the fuel or oil, inside a 5.5mm 4 ply polyester reinforced silicone outer wall. The silicone resists ozone, UV light, weathering and ageing, so it lasts outdoors and in the engine bay without perishing. 🔵 BLUE - FITTING TIP - Push the hose fully onto the pipe, then use hose clips whose range covers about 71mm (the Outside Diameter). Blue silicone gives a bright show-car look that stands out under the bonnet and is easy to trace. Also available in other sizes.