ALadrs Resin Flex Building Plate for Mono 2,6.3x3.7 inch Spring Steel Flexible and Magnetic Base Platform Anycubic Photon 2 3D Printer 160x94mm 2pcs

Applicable model: 160x94 mm is made for Anycubic Photon Mono 2, This resin magnetic flexible steel plate flex bed is also can used for the plate 's size which is longth between 160-170 mm,the width between 94-104mm High durability:Flexible steel plate with high chromium content, easy to bend and clean. Much easier to remove prints and avoid damages during the process, especially for small prints. Good corrossion resistance and prevent rust. Brushed surface provides better adhesion, ensure a perfect print. At the same time, after installing the magnetic printing platform, you will need to re-leveling the 3D printer for excellent printing results. Easy to operate: Traditional DLP light-curing printer platforms must use tools to disassemble, while this resin flexible board can be disassembled by bending. Easier removal of printed models from the resin build surface. Makes it easier to remove prints and avoid damage in the process, especially for small prints. Clever design: The magnetic printing platform is equipped with a handle that makes it easy to install and remove the magnetic printing platform. Installation method: Thoroughly clean and dry the printing platform plate, attach the magnet to the printing platform plate and let it sit for a while to fully seat it, install the spring steel plate on the magnetic base again, and finally reset and level the printer. Set to start printing. It is recommended to print (A4) 3.8mm thick spacers to facilitate the normal zeroing of the Z axis.