Angled 12VHPWR 600W PCIe 5.0 Dual 8 Pin to 16 12+4 Power Cable for RTX 4090 4080 3090TI 4070Ti Graphics Card GPU, ONLY Corsair Supply (Type A)

🔹 TYPE A — 4-PIN SENSE ON BOTTOM | VERIFY YOUR GPU ORIENTATION ⚠️ This cable is Type A: the 4-pin sense connector is located BELOW the 12-pin main block. ⚠️ It is NOT Type B (4-pin on top). If you plug Type A into a Type B GPU, the cable will be forced to bend upward, creating lever stress that can loosen the connection and cause melting. Check your GPU's 12VHPWR port before ordering. 🔹 ONLY FOR CORSAIR TYPE 3 / TYPE 4 — NOT TYPE 5 ⚠️ Specifically wired for Corsair Type 3 and Type 4 modular PSUs (AXi, HXi, HX, RMi, RMx, RMe, RM, SF, CXF). ⚠️ NOT compatible with Corsair Type 5 PSUs (e.g., 2025 RMe, RMx Shift). Type 5 uses a different pinout and smaller connector. Plugging this into a Type 5 PSU will instantly damage your hardware. Verify your PSU model. 🔹 2x8 PIN TO 16 PIN — 16AWG 600W CAPABLE This direct PSU cable converts two PCIe 8-pin outputs into one 16-pin (12+4) 12VHPWR connector. Constructed with 16AWG copper wire to support up to 600W for RTX 4090, 4080, 4070 Ti, and 3090 Ti. ⚠️ Your PSU must have two free PCIe 8-pin ports (labeled "PCI-E" or "VGA", NOT "CPU"). 🔹 60CM LENGTH — STANDARD ROUTING At 60cm, this cable provides ample length for clean cable management in standard mid-tower and full-tower cases. ⚠️ Do not sharply bend the cable at the 16-pin connector—keep the last 3.5cm straight to prevent uneven pressure on the pins. 🔹 ⚠️ SEATING DISCIPLINE IS CRITICAL 12VHPWR failures are almost always caused by partial insertion, not wire quality. You must: Insert the 16-pin connector until the latch clicks and NO gap is visible. Tug test: Gently pull the connector body—it must not move. Do not use adapters in series with this cable. ⚠️ IMPORTANT SAFETY NOTES: Type A only — 4-pin on bottom. Not Type B. Corsair Type 3/4 only — Not Type 5. Fully seat — no gap, latch clicked, tug test passed. PSU ends are PCIe 8-pin — Not CPU 8-pin.