BILITOOLS Adjustable 2-Jaw Gear Puller, Bearing & Pulley Removal Tool 19-35 mm Puller Tool, Anti-Drop Design, Narrow Jaws Fit Tight Spaces, For Armature, Motor Pump Bearings

【Adjustable & Locking 2-Jaw Design】Slide the two jaws along the crossbar to fit the bearing or gear, then tighten the side screws to lock the jaws in position. This helps limit outward jaw movement under load for a more secure setup when pulling small parts from shafts 【Made For Tight Shaft Areas】Two narrow jaws reach around exposed bearings and gears where bulky 3-jaw pullers may not have enough room to open. Ideal for armatures, generator rotors, electric motors, and power-tool rotors when surrounding clearance is limited 【Controlled Axial Removal】The center forcing screw applies steady axial pulling force to remove exposed press-fit bearings or gears from a shaft without hammering or prying. This bearing puller tool helps reduce the risk of damaging shaft ends, rotors, or nearby parts during service 【Forged Construction for Reliable Strength】The pulling jaws are made from 60CrV chrome-vanadium steel, then forged and heat treated for strength, toughness, and fatigue resistance under repeated pulling loads. Built for controlled bearing and gear removal in regular workshop service 【3 Sizes for Different Pulling Needs】Choose 19-35 mm (0.75-1.38 in.), 24-55 mm (0.94-2.17 in.), or 35-80 mm (1.38-3.15 in.) based on the outside diameter of the bearing or gear. Measure the part and available jaw clearance before ordering