Carbusonic Orion Grey convertible roof dye kit, soft top recolouring hood and canvas restorer, restores colour waterproofs fabrics.

Prices from
49.99

Sponsored links

COMPARE ALL WEBSHOPS (1)

Description

Amazon Complete Restoration Kit: Carbusonic MB423, MMCA4, WW12 Fabric Mould and mildew remover, Orion Grey euro canvas dye 3lt large kit with Water proofing Products specially formulated products including acrylic co-polymer, silicone and Bio surfactants to make old, faded, fabric convertible tops, RV and boat covers look like new. A permanent, water based dye that may be applied with either a nylon paint brush, sponge, disposable foam brush or diluted further in an air brush and dries in 2-3 hours Surface Preparation Instructions: First Clean the surface thoroughly with detergent and mould remover Carbusonic MMCA4 using a scrubbing action, rinse and then allow it to dry completely. Next use masking tape to mask off the rear window, glass and body work Application Technique: Start the application of Carbusonic MB423 grey canvas dye at the centre section of the front of the top. Work from side to side, progressing towards the back, maintaining a wet edge as you work towards the rear. The technique is similar to painting with water based paint. Immediately remove any drips on paint, glass or trim with a wet cloth Finishing and Waterproofing Process: If the top is badly faded, apply a second coat after 24 hours drying time. Use heat gun or hairdryer to seal dye then allow the final coat of dry for 8 hours and then follow with two coats of waterproofing solution. Carbusonic WW12 Silicone weather proofing. This Waterproofing Must Be Completely Dry Before Using In Wet Weather. DO NOT use on Vinyl, Acrylic or vinyl impregnated fabric tops. Test small patch for colour first can be diluted with small amount of water Heat Sealing and Protection: After application use a hot air gun or hairdryer to heat the fabric and seal in the dye, apply waterproofing spray with new nano protection formulation supplied in the kit allow to dry before using Kit Contents: 1 litre of MMCA4 mold cleaner, 1 litre of MB423 dye, 1 litre of MW12 nano hydrophobic waterproofing spray, and application sponge included for convenient use

Compare webshops (1)

Sponsored links · Some shops pay us a fee

Sort by:

£ 49.99

Description (1)

Complete Restoration Kit: Carbusonic MB423, MMCA4, WW12 Fabric Mould and mildew remover, Orion Grey euro canvas dye 3lt large kit with Water proofing Products specially formulated products including acrylic co-polymer, silicone and Bio surfactants to make old, faded, fabric convertible tops, RV and boat covers look like new. A permanent, water based dye that may be applied with either a nylon paint brush, sponge, disposable foam brush or diluted further in an air brush and dries in 2-3 hours Surface Preparation Instructions: First Clean the surface thoroughly with detergent and mould remover Carbusonic MMCA4 using a scrubbing action, rinse and then allow it to dry completely. Next use masking tape to mask off the rear window, glass and body work Application Technique: Start the application of Carbusonic MB423 grey canvas dye at the centre section of the front of the top. Work from side to side, progressing towards the back, maintaining a wet edge as you work towards the rear. The technique is similar to painting with water based paint. Immediately remove any drips on paint, glass or trim with a wet cloth Finishing and Waterproofing Process: If the top is badly faded, apply a second coat after 24 hours drying time. Use heat gun or hairdryer to seal dye then allow the final coat of dry for 8 hours and then follow with two coats of waterproofing solution. Carbusonic WW12 Silicone weather proofing. This Waterproofing Must Be Completely Dry Before Using In Wet Weather. DO NOT use on Vinyl, Acrylic or vinyl impregnated fabric tops. Test small patch for colour first can be diluted with small amount of water Heat Sealing and Protection: After application use a hot air gun or hairdryer to heat the fabric and seal in the dye, apply waterproofing spray with new nano protection formulation supplied in the kit allow to dry before using Kit Contents: 1 litre of MMCA4 mold cleaner, 1 litre of MB423 dye, 1 litre of MW12 nano hydrophobic waterproofing spray, and application sponge included for convenient use


Product specifications

Brand Carbusonic
EAN
  • 5056694507504
Color
  • Orion grey

Featured Choice
£ 49.99
To Shop