CPU 8 Pin Male to Dual Pin(6+2) PCIe Power Adapter Cable for Dell PowerEdge R720 720XD R730 and NVIDIA Tesla GPU J30DG 15 inch(38cm), Black

🔹 DELL POWEREDGE ONLY — NOT FOR STANDARD ATX OR NON-DELL SYSTEMS ⚠️ ⚠️ This cable is designed exclusively for Dell PowerEdge server motherboards. It is NOT for standard ATX consumer motherboards, NOT for non-Dell servers, and NOT for Dell workstations (Precision series). ⚠️ Using this cable with a non-Dell system WILL burn or damage your motherboard or GPU. The Dell PowerEdge 8-pin power connector uses a proprietary pinout that is different from standard ATX CPU 8-pin. Verify your system before ordering. 🔹 COMPATIBLE WITH DELL POWEREDGE R720/R730/R530/T620/T630/T640 Designed for Dell PowerEdge servers: R530, R720, R720XD, R730, R730XD, T620, T630, T640. Also compatible with R7910 GPU power split applications. ⚠️ Requires GPU Enablement Kit — Dell official documentation states that GPU installation requires a GPU enablement kit (including low-profile heatsink and GPU power cables). Some servers may not have GPU power connectors pre-installed. ⚠️ If your model is not listed, verify your server‘s GPU power connector before ordering. 🔹 FOR NVIDIA TESLA & 6-PIN/8-PIN GPUs — CHECK POWER REQUIREMENTS Compatible with 6-pin and 8-pin GPUs including: NVIDIA Tesla K80/M40/M60/P40/P100/V100, and consumer GPUs from ASUS, ASRock, Gigabyte, Radeon, Sapphire. ⚠️ Dell official warning: “Do not install GPUs, network cards, or other PCIe devices that are not validated and tested by Dell.” Non-validated GPUs may cause system instability or void your warranty. ⚠️ Power limit: Single 8-pin source provides 150W. Dual 8-pin outputs = 300W total. Do NOT use for GPUs exceeding 288W TGP. 🔹 18AWG TINNED COPPER — 38CM FOR SERVER CHASSIS ROUTING Built with 18AWG tin-coated copper wire for stable power delivery. 38cm (15 inch) length including connectors — standard length for Dell PowerEdge chassis routing. The cable features a CPU 8-pin male connector on one end (connects to Dell motherboard) and two 8-pin (6+2) PCIe male connectors on the other end (connect to GPU). ⚠️ PCIe male connectors feature latches — depress the button before unplugging. 🔹 FACTORY-TESTED — 1-YEAR WARRANTY Each cable is factory-tested for continuity and correct pinout. Backed by a 1-year warranty against manufacturing defects. ⚠️ Key safety warning: Dell community reports “PSU0036 Over current error” when GPU power draw exceeds the server’s PSU capacity. Ensure your PSU wattage and configuration (non-redundant mode may be required) can support the added GPU load. ⚠️ Turn off server, unplug both power cables, and wait 60 seconds before installation. ⚠️ IMPORTANT NOTES: Dell PowerEdge ONLY. NOT for standard ATX or non-Dell systems. Misuse WILL burn hardware. Requires GPU Enablement Kit. Verify your server has GPU power connectors installed. Check power requirements. Single 8-pin source = 150W. Dual = 300W. Do NOT exceed 288W TGP. Dell-validated GPUs recommended. Non-validated GPUs may cause PSU0036 over-current errors. Turn off server and unplug BOTH power cables before installation.