Dremel Multipurpose Spiral Cutting Bit Multipack 561

Dremel 26150561ja Milling Bit. Unleash your creativity with the Dremel Milling Bit! Perfect for freehand cutting and drilling in soft materials like thin soft woods and plastics, this versatile accessory lets you craft intricate shapes with ease. For optimal control and consistent depth, pair it with the Dremel Multipurpose Cutting Attachment. Achieve best results by using the bit´s sides, moving clockwise, and starting cuts at a 45-degree angle. Operate at high speeds with a slow, steady feed rate, avoiding excessive pressure. Experience precise shaping and drilling for your DIY projects. Best for cutting and drilling in soft materials such as soft woods (less than 12mm thick) and plastics. Great to go freehand to create the shapes you like.We recommend to use this bit with the Dremel Multipurpose Cutting Attachment, because it's designed to help you maintain depth during the application. It's important that the depth of the guide supports the cutting blade extending beyond the material by about 0.6 cm. (.25). If the bit extends out too far beyond the material, it can be more difficult to control and can actually snap the bit. Best control of the bit occurs when moving in a clockwise direction. Begin the cut at a 45 degree angle and then bring the accessory to 90 degrees. The tool should be set at a high speed, the feed rate of the material or the tool through the material should be slow and gradual. Too much pressure will cause this accessory to get red hot. Using the tip of the bit is not the best way to cut: we recommend using the sides of the bit, where the full cutting capacity of the fluting can be put to use.Materials to use on:- Soft materials like soft woods (less than 12mm thick), plastics, glass fibers and thin foils of aluminum.Recommended speed- Aluminum 20.000: 35.000 RPM- Hardwood 20.000: 35.000 RPM- Softwood 20.000: 35.000 RPM- Plastic 10.000-15.000RPMTechnical details for Spiral Cutting Bits Multipurpose:- Sandwich material- Veneered woods- Brick- Drywall/Plasterboard- Aerated Concrete- Ceramic- Softwood- Hardwood- Soft Metal- Plastic- Plexiglass- RPM- AttachmentSpecifications:- Shank diameter: 3,2 mm- Working diameter: 3,2 mm- Working length: 30 mm- Accessory length: 65,0 mm- Width: 3,0 mm- Maximum RPM: 35.000 1/min- Length: 3,0 mm- Height: 62,0 mm. tradeinn Bricoinn

Dremel accessories (561) spiral cutting bits are designed for cutting and driling in soft materials Best for use on softwood (up to 12mm thick), plastic and drywall Working length up to: 20 mm, Cutting diameter: 3.2 mm Recommend to use with the Dremel Multipurpose Cutting Attachment (566) to help maintain depth during the cutting and drilling Fits with all Dremel Multi-/Rotary tools or other 3,2mm shank size multi- / rotary tools