E3D RapidChange Revo™ Brass 1.75mm 0.8mm Nozzle

E3d Rapidchange Revo™ Brass 1.75 Mm 0.8 Mm 3d Printer Nozzle. EU Plug.Experiment freely.With nozzle swapping this easy, you´re free to experiment with nozzle sizes you might not have used before.Set your 3D printer up for ultra-fine or ultra-thick extrusion widths in no time.Print large objects in less time or tiny objects with high resolution.Frustration-free Each Revo Nozzle is a preassembled nozzle and Heat Break in one unit, so there´s no hazardous hot tightening and no chance of incorrect assembly.Say goodbye to frustrating Hot end leaks and enjoy reliable FDM 3D printing.Rapid identification.Identify nozzle sizes at a glance, thanks to a colour-coded silicone sock.Plus, each Revo Nozzle has its size engraved into it with easy-to-read numbers, so there are no confusing identification markers to learn.Note:- Revo™ Nozzles are not compatible with V6-style heater blocks.- You may need to adjust your Z offset when changing nozzles.Warning:- This product can expose you to chemicals including Mineral Oils, which is known to the State of California to cause cancer, and Lead and Nickel, which are known to the State of California to cause cancer and birth defects or other reproductive harm.Specifications:Brass:- Input diameter:1.75mm.- Maximum temperature:300°C. tradeinn Techinn

Change your 3D printer's nozzles in less than 60 seconds without tools or hot squeezing, just use your fingers! If you can unscrew a tube of toothpaste, you can use a Revo nozzle. Simply screw one anywhere cold from Revo and you're ready to 3D print. Experiment freely. With nozzle exchange so easy, you can experiment with nozzle sizes that you may not have used before. Set up your 3D printer for ultra-thin or ultra-thin extrusion widths in no time. Print large objects in less time or small objects with high resolution. No frustrations. Each Revo nozzle is a pre-assembled nozzle and HeatBreak in one unit, so there is no dangerous hot tightening and no chance of improper assembly. Say goodbye to frustrating HotEnd leaks and enjoy reliable 3D printing! No frustrations. Each Revo nozzle is a pre-assembled nozzle and HeatBreak in one unit, so there is no dangerous hot tightening and no chance of improper assembly. Say goodbye to frustrating HotEnd leaks and enjoy reliable 3D printing! An expanding range. We are ready to make RapidChange nozzles in any size. Currently, we have brass nozzles in 0.15mm, 0.25mm, 0.4mm, 0.6mm and 0.8mm, with many more compatible nozzles to follow later. Wear-resistant and high-flow variants are already on our roadmap and will continue over time.