John Guest Speedfit FLX17P 15 mm x 300 Length Braided Fexi Hose (Bag of 2)

Zoro Tools

Flexi hoses are manufactured to a high quality you would expect from Speedfit. The hoses are suitable for hot and cold water services, have a working pressure of 10 Bar and have WRAS and NHBC approval. Length: 300mm. Push-fit Solution for Plumbing & Heating Systems For use with mains fed and indirect cold water systems, vented and unvented hot water systems, vented and sealed central heating systems. Pipes Speedfit fittings can be used with copper pipe to BS EN 1057 and Speedfit cross-linked polyethylene (PEX) Barrier Pipe to BS7291. NOT to be used with gas, fuel oil or compressed air applications. Speedfit fittings cannot be used on stainless steel pipe. Standards Speedfit products are designed and manufactured under a fully integrated system assessed by B.S.I. to BS EN ISO9001. They are approved by the Water Regulations Advisory Scheme and BBA. Speedfit PEM and PKM fittings and Speedfit barrier pipe are kitemarked to BS7291 Part 1 and 3, Class S. (Licence No. KM39767). Pipe in ceilings and roof voids should be clipped every metre and should not be fitted any closer than 60mm from the end of the fitting. Pipe should be adequately supported by pipe clips to prevent undue stress (side load) on fittings. Can only be used with water or oil based paint, not cellulose based paints, paint thinners or strippers, solder flux or acid-based descalents or aggressive household cleaning products. Speedfit products, when used indoors, are not affected by sunlight. When used outdoors protect from ultra violet light by lagging or painting. It is recommended that all installations are checked prior to use to determine that a seal has been made.

ManoMano

JG Speedfit x Speedfit flexi hose (braided) for the connection of plastic or copper pipe. The flexi hose is ideal for the connection of two pipes where the angle is too steep to bend the pipe to make a connection. Simply push the push-fit fitting fully onto the pipe. To demount the connection, push the collet towards the body of the push-fit fitting and pull the pipe release. The JG Speedfit x Speedfit flexi hose (braided) is quicker and easier to install in confined spaces than traditional methods as it eliminates the need for hot works or tools. Designed, manufactured and assembled in the UK. An alternative to hard piping to a tap or fixture Flexible design makes installation hassle free Safe flame-free installation, with no hot works, glue or flux Braided stainless steel outer layer protects the internal feed from damage Grip & Seal collet with stainless steel teeth and main O-Ring seal Compatible with Speedfit PEX and polybutylene plastic pipe (inserts required) and copper pipe

Plumbing Superstore

The John Guest Speedfit Flexi Hose is a push-fit connector, perfect for joining plastic and copper pipes to a male thread appliance, like taps. Designed and made in the UK, it features a grip and seal collet arrangement. Simply push the fitting onto the pipe and screw the nut to the appliance thread. To release, push the collet towards the fitting body and pull out the pipe. This hose is ideal for tight spaces and eliminates the need for hot works on site. It is sold individually, available in various sizes, and WRAS approved. With a pressure rating of 6 Bar at 65C, this hose is produced in West London and Maidenhead, ensuring the highest quality. Note that this hose is not suitable for central heating systems and requires a manufacturer's insert for plastic pipes.. John Guest Speedfit Flexi Hose - 15mm x 15mm x 300mm Stainless Steel

Amazon

Suitable for domestic hot and cold water Very flexible Removes the need for small pipe runs with lots of joints Easy connection between pipes, Weight: 0.22 Pounds, Manufacturer: John Guest