John Guest Speedfit PSE3203W 15 mm x 3/4 � Female Coupler Tap Connector Pack Of 5

Zoro Tools

Only requires simple hand tightening for connection to terminal taps. Push-fit Solution for Plumbing & Heating Systems For use with mains fed and indirect cold water systems, vented and unvented hot water systems, vented and sealed central heating systems. Pipes Speedfit fittings can be used with copper pipe to BS EN 1057 and Speedfit cross-linked polyethylene (PEX) Barrier Pipe to BS7291. NOT to be used with gas, fuel oil or compressed air applications. Speedfit fittings cannot be used on stainless steel pipe. Standards Speedfit products are designed and manufactured under a fully integrated system assessed by B.S.I. to BS EN ISO9001. They are approved by the Water Regulations Advisory Scheme and BBA. Speedfit PEM and PKM fittings and Speedfit barrier pipe are kitemarked to BS7291 Part 1 and 3, Class S. (Licence No. KM39767). Pipe in ceilings and roof voids should be clipped every metre and should not be fitted any closer than 60mm from the end of the fitting. Pipe should be adequately supported by pipe clips to prevent undue stress (side load) on fittings. Can only be used with water or oil based paint, not cellulose based paints, paint thinners or strippers, solder flux or acid-based descalents or aggressive household cleaning products. Speedfit products, when used indoors, are not affected by sunlight. When used outdoors protect from ultra violet light by lagging or painting. It is recommended that all installations are checked prior to use to determine that a seal has been made.

ManoMano

JG Speedfit female coupler tap connector push-fit fitting for the connection of plastic or copper pipes to a male thread fixture or appliance. The female coupler is ideal for the connection of taps and toilets. Simply push the push-fit fitting fully onto the pipe and hand turn onto the thread. To demount the connection, push the collet towards the body of the push-fit fitting and pull the pipe to release. The JG Speedfit female coupler tap connector is up to 40% faster to install than traditional methods and is easier to use in confined spaces by removing the need for hot works and tools. Designed, manufactured and assembled in the UK. Instant push-fit and hand-tighten connection Install and demount in seconds without tools Safe flame-free installation, with no hot works, glue or flux Grip & Seal collet with stainless steel teeth and main O-Ring seal Compatible with Speedfit PEX and polybutylene plastic pipe (inserts required) and copper pipe Suitable for hot and cold water and

Amazon

Suitable for domestic hot and cold water Simple push fit action enables easy installation Truly demountable without damage to pipe or fitting No risk of fire or flames Hand tighten no tools required, Weight: 0.22 pounds, Manufacturer: John Guest