LavaPlumb Copper Press Fit Stop End Cap 28mm 10 Pack, M Profile Fitting Tool Required Not Push Fit, Permanent Single Seal, WRAS DVGW and BSI Approved, No Flame or Solder

Press Tool Required - Not Push Fit: This is an M Profile press fit fitting. You need a compatible press gun and the matching M15, M22 or M28 jaw to compress the sleeve and create a permanent seal on the pipe end. It cannot be hand-assembled. Permanently Seals a Pipe End - Single Press Connection: Push the open pipe end into the cap and press with your tool. The EPDM O-ring creates a permanent, water-tight termination. Use it to cap off any 15mm, 22mm or 28mm copper pipe you are not connecting. WRAS, DVGW and BSI Approved: Certified for hot and cold water services, vented and unvented heating systems, and chilled water. Rated to 16 bar from -24 deg.C to 110 deg.C. Compatible with BS EN 1057 R250 and R290 copper tube. EPDM O-Ring Seal - No Ongoing Maintenance: Once pressed, the cap is a permanent fitting. The EPDM sealing element is rated for decades in standard UK water and heating conditions. No Naked Flame - No Hot Works Permit: No solder, no flux, no open flame. Cap off live pipe ends in occupied buildings without hot works permits or fire protection measures.