Mcbazel 10Pcs 2K3 Ohm Potentiometer Replacement for PS5 Dual Sense Controller, Trimmer Sensor Module ALPS Analog Joystick with Open Tool Kit

2.3K OHM ALPS MATCH: Each trimmer potentiometer in this set is rated 2.3K Ohm, the resistance the ALPS analogue joystick modules for PS5 DualSense controllers are built around, and every sensor is checked before it is packed. 13 PIECES IN THE BOX: The kit holds 10 trimmer potentiometer sensors that each measure 1.5 cm wide and 0.8 cm tall and carry three solder pins, plus a 10.8 cm cross-head screwdriver, a 9 cm pry tool and a 3 cm pry board, which is where the 13 in 1 count comes from. TEN SENSORS FOR REPEAT REPAIRS: Because the pack holds ten potentiometers rather than one or two, you can work through both analogue sticks, keep spares for the next fault, and repair rather than replace a drifting controller for PS5. SOLDERING IS REQUIRED: This is a board-level part, so you need an electronic soldering iron and a small soldering wire, and the old holes should be cleaned out before the new potentiometer goes in. The iron and the wire are not supplied in this kit. MADE FOR PS5 DUALSENSE, NOT FOR PS5 EDGE: These sensors are sold as replacement parts for PS5 DualSense controllers and are marked not for the PS5 Edge controller, so please confirm which pad you own before you order. This is not an official item for Sony.