Switch Analog 3D Joystick Replacement & Repair Tool Kit for Switch/Switch OLED/Joy Con/Switch Lite Controller, Mcbazel 2PCS Joysticks Tri Wing Cross Screwdriver Tools White

BUILT FOR SWITCH, SWITCH OLED AND SWITCH LITE: Each 3D analogue joystick module in this kit is made as a replacement part for the left and right Joy-Con controllers for Nintendo Switch and for Nintendo Switch OLED, and for the built-in sticks for Nintendo Switch Lite. Both modules in the pack are identical, so you can fit either one to a left or a right controller without matching left and right parts. SIX PIECE REPAIR SET IN ONE PACK: This kit includes 2 analogue joystick modules, a Y1.5 tri-wing screwdriver, a 1.5 cross screwdriver, one pair of curved ESD tweezers and one plastic crowbar, so the strip-down and the refit need no extra tools. Both screwdrivers measure 10.8 cm and have a weak magnetic tip that holds the tiny screws while you work. The tweezers measure 12.2 cm and the crowbar measures 8.6 cm. SWAP OUT A DRIFTING STICK: A worn joystick that registers movement on its own is the usual cause of drift, and fitting one of these 20 x 13 mm modules puts a fresh 360 degree stick and a fresh ribbon tail into the controller. The thumb cap comes already fitted on each module, so nothing has to be prised off the old part and reused. Replacing one worn part keeps a working shell, battery and buttons in service instead of retiring the whole controller. CALIBRATE AFTER EVERY REFIT: Once the new joystick is seated and the shell is back together, open the settings for Nintendo Switch and run Calibrate Control Sticks, because the console keeps the calibration data of the old stick until you clear it. Work slowly around the ribbon cable and the battery connector, and the tweezers and the crowbar in the pack are there to keep your fingertips off both. Note: Not compatible with switch 2