Victron Energy Cyrix-Li-Charge 12/24-Volt 230 amp Intelligent Charge Relay

Victron Energy Cyrix-li-charge 12/24v-relay 230a. The Cyrix-Li-Charge will connect a battery charger with a 3 second delay:if the load disconnect output of the VE.Bus BMS is high, and if it detects 13.7 V (resp.27.4 V or 54.8 V) or more at its battery charger connection terminal, and if it detects 2 V or more at the battery terminal (the Cyrix will remain open if not connected to the battery).The Cyrix-Li-Charge will deactivate immediately whenever its control input becomes free-floating, indicating cell over-voltage or cell over-temperature.In general, a cell overvoltage alarm will reset shortly after charging stops.The Cyrix will reconnect the charger after a 3 second delay.After 2 attempts to reactivate with 3 seconds delay, the delay increases to 10 minutes.Whenever the battery voltage is below 13.5 V (resp.27 V or 54 V), the Cyrix will switch off with a delay of 1 hour.Note 1:In case of zero discharge current, or a small discharge current, the Cyrix will not disconnect shortly after the charger has been switched off and/or disconnected, because the battery voltage will still be higher than 13.5V.Note 2:If, after the Cyrix has been disconnected, the output of the battery charger immediately increases to 13.7 V or more, the Cyrix will reconnect with a 3 second delay. tradeinn Waveinn

Victron Energy Cyrix-Li-Charge will connect a battery charger with 3 seconds delay. Victron Energy Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature In general, a cell over voltage alarm will reset shortly after charging has been stopped. Victron Energy Cyrix will then reconnect the charger after a delay 3 seconds When Victron Energy Cyrix-Li-Charge is engaged (charger connected to battery) it will disengage after 1 hour to check if the charger is still enabled If, after the Victron Energy Cyrix has disengaged, the output of the battery charger immediately increases to 13 V or more, Victron Energy Cyrix will reengage, with a 3 seconds delay Note: In case of zero discharge current, or a small discharge current, Victron Energy Cyrix will not disengage shortly after the charger has been switched off and/or disconnected, because battery voltage will remain higher than 13.5 V