Victron Energy MultiPlus Pure Sine Wave Inverter Charger for 70 amp Battery, 1600VA 12 Volt 230V

Victron Energy Multiplus 12/1600/70-16 Charger. Experience ultimate power management with the Victron Energy MultiPlus 12/1600/70-16. This compact powerhouse combines a 1600VA pure sine wave inverter, a 70A adaptive battery charger, and a high-speed AC transfer switch. Its intelligent PowerAssist feature boosts limited shore or generator power for peak loads, while PowerControl prevents overloads. With proven reliability, high starting power for demanding tools, and remote monitoring via the free VRM app, it’s the all-in-one solution for robust, uninterrupted power, fully compatible with modern Lithium-Ion batteries. VICTRON Energy MultiPlus Inverter Charger 12V/1600VA/70-16 the MultiPlus brings toge ther, in a single compact housing, a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch.It allows monitoring and control of the system locally (LAN) or remotely with the free VRM app the MultiPlus brings toge ther, in a single compact housing, a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch.Victron Multiplus Inverter Chargers are compatible with Lithium-Ion batteries.Technical features.Proven reliability the full-bridge plus toroidal transformer topology has proven its reliability over many years the Inverter is short-circuit proof and protected against overheating, whe ther due to overload or high ambient temperature.PowerControl - Power limiting from generator, shore power or grid (800VA/1200VA).A maximum current from the generator or the pontoon can be set on the Multi Control Panel the MultiPlus will then take over other AC loads and use the excess current for charging, thus avoiding overloading the generator or shore power.PowerAssist - Increasing the electrical capacity of the shore power intake or generator .When a power peak is required for a short period of time, as is often the case.The MultiPlus will immediately compensate the possible lack of power from the mains or generator current with power from the battery.When the load is reduced.The excess power is used to recharge the battery.High starting power.Necessary for starting loads with high inrush current, such as converters for LED lamps, halogen lamps or power tools.Search mode.When the search mode is activated.The Inverter consumption in no-load operation decreases by approximately 70% in this mode the Multi, when operating in inverter mode, switches off if there is no load or too little load, and switches back on every two seconds for a short period of time.If the output current exceeds a preset level.The Inverter will continue to operate.otherwise.The Inverter will switch off again.Programmable relay the programmable relay is by default configured as an alarm relay, i.e the relay will de-energize in case of alarm or pre-alarm (inverter is too hot, input ripple is almost too high and battery voltage is too low).Remote On/Off/Charger on connector Three-pole connector the first configuration can be done at Fusion Solar Energy at no extra charge for you to receive your fully customized equipment. tradeinn Waveinn

VICTRON ENERGY PURE SINE WAVE INVERTER: The Victron Energy Multiplus inverter charger is a powerful true sine wave inverter and a sophisticated battery charger with adaptive charge technology POWER ASSIST: With the unique Power Assist feature the MultiPlus solar inverter will prevent overload of a limited AC source, such as a generator or shore power connection POWER WITHOUT INTERRUPTION: In the event of a grid failure, or when shore or generator power is disconnected, the Victron inverter is activated fast, within 20ms, and takes over the supply to the connected loads PARALLEL OPERATION: Up to 6 Victron Energy MultiPlus Purew Sine Wave Inverter units can operate in parallel to achieve higher power output, In addition to parallel connection, three units can be configured for three-phase output. INSTALLATION: Incorrect installation can be hazardous, Please consult a licensed professional and follow all applicable electrical codes during installation