VMS CA Glue Filler VMS.AX.10

VMS CA Glue Filler Powder for Fast-Curing Model Repairs VMS CA Glue Filler AX10 is a fine powder designed to be mixed with cyanoacrylate (CA) glue to create a fast-curing modelling putty. It provides a practical way to fill gaps and make repairs without the extended drying time associated with conventional modelling putties. When combined with CA glue, the powder produces a putty-like mixture that cures to a solid filling. Once dry, the material can be sanded smooth, preparing repaired areas for further modelling work. The filler can also be applied in layers or combined with other modelling putties when a repair requires more than one application. Fast-Curing, Sandable Gap Filler VMS CA Glue Filler is intended for situations where standard modelling putty takes too long to dry or when a quick filling solution is needed during assembly. Mixing the fine powder with CA glue creates a filling compound that can be applied directly to gaps in model components. The resulting material hardens quickly and can then be worked with abrasive paper to produce a smooth finish. VMS recommends combining the powder with VMS Flexy SLOW CA Glue when additional working time is required. The slower adhesive provides a longer open time, allowing more opportunity to mix and position the filler before curing. How to Mix and Apply VMS CA Glue Filler The filler is prepared by combining a small quantity of CA glue with the powder until the mixture reaches a putty-like consistency. Dispense a portion of CA glue onto a piece of styrene, glass or a metal sheet. Avoid cardboard, as it absorbs the adhesive. Add some VMS CA Glue Filler powder to the glue. Mix the powder and adhesive using a toothpick until the desired putty consistency is reached. Apply the mixture promptly to the gap or area requiring filling. Level the applied putty with a hobby knife to minimise excess material around the repair. Once fully cured, sand the filling with 600-grade abrasive paper, followed by 1000-grade paper for a smoother finish. Working promptly is important because the mixed filler cures quickly. Levelling the material before it hardens also helps reduce the amount of sanding required afterwards. Layered Filling and Dropper Bottle VMS CA Glue Filler can be built up in successive layers when a single application is insufficient. It can also be used alongside other modelling putties, allowing you to combine different filling materials during repair work. The powder is supplied in a dropper bottle with a fine dispensing tip. This allows controlled addition of powder when preparing small quantities of filler, helping modellers adjust the consistency of each mixture. Browse our model glue range for suitable CA adhesives, or see more VMS modelling products.