Y&H 2000W Wind Power Grid Tie Inverter With Limiter Sensor,Dump Load,45 90VDC 230VAC For AC 48V Turbine Generator

The test point should be at the DC side of the built-in rectifier of the inverter, but you can calculate from 3 phases of AC output voltage of the wind turbine to get the DC voltage, the formula is Vac = Vdc/1.732. For example, if the DC input voltage range of the inverter is 45~90V, then the wind turbine's output AC range of the should be 45/1.732~90/1.732 = AC25.9V~ 51.96V. This model grid tie has designed for wind turbines that put out 3 phases AC voltage.It can maintain the rotating speed of the wind turbine and keep the voltage from the wind turbine always at the range of the rated range of the grid tie inverter.It also has a high voltage protection function,when the wind is too big,and the dump load controlling system can’t keep the output voltage from the wind turbine,the controller will disconnect itself from the wind turbine,so it is very safe to be used Wind Grid Tie Inverter with Limiter Sensor, which can prevent excess power from going to the public grid.Select the internal limiter mode,inverter will work under limiter mode,output power of the inverter will be determined by load power. The backlit LCD display gives you a clear picture of the inverter's operating status.all adjustable parameter.The status of errors will be displayed with red letters on the grid tie inverter LCD display. We have energy storage batteries for sale, which can be customised from 1 kWh to 10 kWh. In order to avoid under-capacity or excessive waste of power generation. Battery capacity is based on the specific usage requirements of the load and application scenario. You can contact us for technical support. Easy installation,Can be paralleled on AC side.Overload protection ,Anti-island protection,Short-circuit protection/Reverse polarity protection