Bull Cricket Bat Gripping Cone Rubber Grip Applicator Wooden Shaped Easy Fitting

STEP 1 – Flip your new rubber grip inside out. Slide the top end (which will go on the bat handle) over the narrow end of the grip cone, pushing it as far as possible. Once the grip is securely on the cone, roll it back on itself and off the narrow end of the cone. STEP 2 – Turn the grip back around, then place the unrolled section over the narrow end of the cone again. Roll the grip over the remaining unrolled part, moving it toward the wide end of the cone. STEP 3 – With the grip fully rolled and positioned near the wide end of the cone, place the wide end of the cone over the top of your bat handle. Carefully roll the grip off the cone and onto the handle. STEP 4 – Continue rolling the grip down toward the bat’s shoulders. Once the grip is near the bottom of the handle (close to the shoulders or splice area), begin unrolling it back up the handle. STEP 5 – Adjust the grip's alignment and positioning for a precise fit. Trim any excess if needed. (Repeat these steps if adding a second grip over the first one).