John Guest Speedfit 15MM Emergency Shut Off Tap

Zoro Tools

Comply with water regulations, building regulations and British Standards. Push-fit Solution for Plumbing & Heating Systems For use with mains fed and indirect cold water systems, vented and unvented hot water systems, vented and sealed central heating systems. Pipes Speedfit fittings can be used with copper pipe to BS EN 1057 and Speedfit cross-linked polyethylene (PEX) Barrier Pipe to BS7291. NOT to be used with gas, fuel oil or compressed air applications. Speedfit fittings cannot be used on stainless steel pipe. Standards Speedfit products are designed and manufactured under a fully integrated system assessed by B.S.I. to BS EN ISO9001. They are approved by the Water Regulations Advisory Scheme and BBA. Speedfit PEM and PKM fittings and Speedfit barrier pipe are kitemarked to BS7291 Part 1 and 3, Class S. (Licence No. KM39767). Pipe in ceilings and roof voids should be clipped every metre and should not be fitted any closer than 60mm from the end of the fitting. Pipe should be adequately supported by pipe clips to prevent undue stress (side load) on fittings. Can only be used with water or oil based paint, not cellulose based paints, paint thinners or strippers, solder flux or acid-based descalents or aggressive household cleaning products. Speedfit products, when used indoors, are not affected by sunlight. When used outdoors protect from ultra violet light by lagging or painting. It is recommended that all installations are checked prior to use to determine that a seal has been made.

ManoMano

JG Speedfit emergency shut off tap allows the user to stop the flow of water to a fixture or zone in the event of an emergency or repair work. Simply push the valve fully onto the pipe and turn the knob on top of the push-fit fitting to allow or restrict the flow of water. To demount the connection, push the collet towards the body of the push-fit fitting and pull the pipe to release. The JG Speedfit emergency shut off tap is quicker and easier to install in confined spaces than traditional methods as it eliminates the need for hot works or tools. Designed, manufactured and assembled in the UK. Simple hand turn of the knob instantly isolates water Install and demount in seconds without tools Safe flame-free installation, with no hot works, glue or flux Grip & Seal collet with stainless steel teeth and main O-Ring seal Compatible with Speedfit PEX and polybutylene plastic pipe (inserts required) and copper pipe Suitable for hot and cold water (not suitable for central heating systems)