Queenbox 70cm/27 Shower Seals for Glass screens, Door Bottom Seal, Seal Strip Frameless 3/8 inch(10mm) Gap 13mm

shower door bottom seal, using transparency Plastic material, shower door seal strip is durable corrosion-resistant, good anti-aging performance. shower door bottom seal can create a wonderful shower environment for you to keep the bathroom dry and tidy. EASY TO INSTALL:Installation takes only a few minutes and no adhesive is required. Remove the old shower door sweep from the door, cut the new product to the same length as the old shower door seal strip, place the new shower seal for glass door under the shower bottom seal pushing up from the side closest to the hinge. When the shower door bottom seal is clamped to the glass door and you're done. Design:The middle bayonet of the water retaining strip adds two locking devices to prevent the problem of the shower seal for glass door falling off. Once the glass is clamped, it will not fall off easily unless it is removed by the human force. Shower door bottom seal upper part of the seal is hard plastic, and therefore it holds onto the door very well. The lower part, (flaps) is softer plastic, so when they contact the floor they bend allowing the door to close and open. EASILY CUT TO SIZE: 27.56inch/70cm/700mm length, Shower seal easily fit most Frameless Glass doors (Sliding Shower Doors).but if you require a shorter seal then you can simply cut the seals down to the preferred size. This can be easily done with a hacksaw (We hold no liability for damage done to seals while cutting them) Universal:Fits 3/8 inch(10mm) Glass Thick Frameless Glass Door, Shower Seal gap up to 13mm, effectively prevent water from overflowing in the bathroom and keep the bathroom clean